![]() Subject: Aruba to Netgear managed switch, port downĭo I need to run this command on port 3, even if its not showing up as enabled on the show running config for interface 3? I also have the Netgear managed switch's MAC on there. Status and Counters - Port Address Table - 3īut when I login to the webgui, I can see 9 MAC address, because that's the limit is set to. When I do a show mac-address 3 (this is the uplink port to the Netgear switch), I get this This managed switch is acting as a dummy switch, meaning no VLANs, except the native VLAN 1. I even tried doing a factory reset on the Netgear managed switch, but its not working. ![]() But, if I connect it back to the Netgear dummy switch, its fine. I did add the Netgear switch's MAC address, but its still down. This port had a Netgear unmanaged dummy switch connected, and everything was fine.īut, when I connected a Netgear managed switch to this port, the Netgear switch is not getting any connection from Aruba. On port 3 of the Aruba switch, there's port-security enabled.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |